P95D Printer - Settings - GE Voluson E8 Service Manual
Hide thumbs
Also See for Voluson E8:
- Quick manual (37 pages) ,
- Service manual (366 pages) ,
- Technical publication (127 pages)
Table of Contents
Advertisement
GE H
DRAFT
EALTHCARE
D
KTD102576, R
IRECTION
3-7-4-2
P95D Printer - Settings
1.) Printer Settings directly on the B&W Printer:
a.) Press the BRT button on the printer and adjust Brightness to "0" by using the turning knob.
b.) Press the CONT button on the printer and adjust Contrast to "0" by using the turning knob.
c.) Press the SHARP button on the printer and adjust Sharpness to "3" by using the turning knob.
d.) Press the FUNC button on the printer and adjust Gamma to "r5" by using the turning knob.
e.) Press the BRT button twice to save and exit.
Brightness: 0
Sharpness: 3
2.) Assign the Printer to the remote keys P1, P2, P3 and/or P4;
see:
3.) Activate USB Serial number:
a.) Turn off Printer and wait 5 seconds.
b.) Press and hold the buttons COPY + CONT and power on the printer.
c.) Press the FUNC button -> the display changes to "U0".
d.) Adjust the value to "U2" via turning knob.
e.) Press the FUNC button again -> the display changes to another value (normally "F0").
f.) Power off the Printer.
7
DRAFT (A
EVISION
Figure 3-42 Printer Settings - B&W Printer
Section 3-7-5 "Remote Control Selection" on page
When the Display changes to "S1" the buttons can be released.
Chapter 3 - Setup Instructions
23, 2012)
UGUST
Contrast: 0
Gamma: 5
3-48.
V
E8 / V
OLUSON
OLUSON
S
M
ERVICE
ANUAL
3-43
E6
Advertisement
Chapters
Table of Contents
Troubleshooting
