SECTION 1 This section is extracted from GENERAL instruction manual. Notes on chip component replacement Flexible Circuit Board Repairing • Never reuse a disconnected chip component. • Keep the temperature of the soldering iron around 270°C during • Notice that the minus side of a tantalum capacitor may be dam- repairing.
SECTION 4 Ver 1.2 2001.06 EXPLODED VIEW NOTE : -XX, -X mean standardized parts, so they may The mechanical parts with no reference number have some difference from the original one. in the exploded views are not supplied. Items marked “ * ”are not stocked since they are Hardware (# mark) list and accessories and pack- seldom required for routine service.
ECM-MS907 Ver 1.2 2001.06 SECTION 5 ELECTRICAL PARTS LIST AMPLIFIER NOTE : SEMICONDUCTORS Due to standardization, replacements in the In each case, u : µ , for example : When indicating parts by reference parts list may be different from the parts speci- uA..
Page 7
ECM-MS907 US Model Canadian Model SERVICE MANUAL AEP Model E Model Ver 1.1 1999.12 CORRECTION - 1 Correct your Service Manual as shown below. INCORRECT CORRECT Page Ref. No. Part No. Description Remark Part No. Description Remark 3-701-442-01 WASHER, POLYETHYLENE 3-701-442-21 WASHER, 4.5 (t:0.5)
ECM-MS907 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2001.06...