Power Key And System Power Up; Modes Of Operation - Nokia Lumia 1320 Service Manual
Hide thumbs
Also See for Lumia 1320:
- Quick start manual ,
- User manual (125 pages) ,
- Quick manual (27 pages)
Table of Contents
Advertisement
RM-994/ RM-995/ RM-996
System Module
Parameter
Higher extreme voltage
(Fast charging)
SW shutdown
The PM8038 PMIC determines the system boot up (or shutdown) by comparing the battery voltage with the
UVLO thresholds.
Parameter
Threshold voltage, falling
Threshold voltage accuracy
Hysteresis
UVLO detection interval
The hysteresis acts the following way:
●
For rising threshold (during power up), the threshold would be 2700 + 175 mV
●
For falling threshold (to determine shutdown), the threshold would be 2700 mV
Power key and system power up
When the battery is placed in the phone, the power key circuits are energized. When the power key is
pressed, the system boots up (if an adequate battery voltage is present).
Power down can be initiated by pressing the power key again and the system is powered down with the aid
of SW. The power key is connected to EM ASIC (U1100) via the PON_RESET_N signal.
Modes of operation
Mode
NO_SUPPLY
(Dead) mode means that the main battery is not present or its voltage is too low
(below U1100 master reset threshold) and that the back-up battery voltage is too low.
BACK_UP
The main battery is not present or its voltage is too low but back-up battery is
adequate and the 32 kHz oscillator is running.
PWR_OFF
In this mode (warm), the main battery is present and its voltage is over U1100 master
reset threshold. All regulators are disabled, PON_RESET_N is on low state, the RTC
is on and the oscillator is on. PWR_OFF (cold) mode is almost the same as
PWR_OFF (warm), but the RTC and the oscillator are off.
RESET
RESET mode is a synonym for start-up sequence. RESET mode uses 32 kHz clock to
count the RESET mode delay (typically 16ms).
SLEEP
SLEEP mode is entered only from PWR_ON mode with the aid of SW when the
system's activity is low.
FLASHING
FLASHING mode is for SW downloading.
Voltage
4.2V
SW Shutdown
3.49V
Table 9 UVLO performance specifications
Comments
Programmable value
NOKIA INTERNAL USE ONLY
Copyright © 2013 Nokia. All rights reserved.
others
Min
Typ
1.500
2.700
-5
-
100
175
-
1.0
Description
Max
Units
3.050
V
+5
%
250
mV
μs
-
Page 133
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
