Table of Contents
Advertisement
Operation
Use the following procedure to start up the unit.
Inserting Cassettes in the Bins
You can insert up to nine cassettes.
Use the following procedure to insert cassettes in the
bins.
1
Connect the power.
Connect the optional power cord between an AC
outlet and the AC IN connector on the rear panel of
this unit.
2
Turn the POWER switch on.
3
Turn the door key switch to the "Open" position.
"Closed" position
CLOSE
n
O
The front door opens.
4
Insert the cassettes in the bins.
Push a cassette into the bin until the retainer hooks
engage when the cassette is in the correct position.
Cassette
Seen from the side of the bin
• Check that there are no obstructions on the hand or
"Open" position
• Make sure that the cassette is inserted facing the
CLOSE
• If an S-cassette is not inserted along the guides, the
O
• If you insert a cassette in error, press down the two
5
6
Always power on this unit before starting up the host
computer.
Retainer hooks
You can load a combination of L- and S-cassettes.
When inserting an S-cassette, insert it along the
central guides as shown in the figure.
Guide arms (yellow)
Guides
L-cassette
Seen from the front of the bin
Notes
the elevator.
correct way, or the unit will not operate.
unit will not operate.
retainer hooks, and the cassette will spring out.
Close the front door.
Turn the door key switch to the "Closed" position.
The unit starts operating.
Note
S-cassette
13(E)
Advertisement
Table of Contents
