o
Chapter 2. DCAF Session Installation
o
o
o
..
o
Summary of Procedures
Preparation
First collect the worksheets from the Planning Guide, GA33-0457, at your
workstation, then consult the summary of procedures in Table 2-1.
Table 2-1. DeAF Session Installation Procedures
Procedures
For the Remote Workstation
For the Service
Processor
Verifying hardware
See Chapter 1, "Introduction to Remote
Pre-configured as
and programming
Consoles and DCAF."
a DCAF target
requirements.
workstation.
DCAF program
See "Installing DCAF" on page 2-2.
Non applicable.
installation or
Already
upgrade.
pre':configured.
TCP/IP program
SeeTCP/IP installation guide delivered
Non applicable.
installation or
with the product.
upgrade.
CS/2 and CM/2
See "Customizing CS/2 and CM/2" on
See Chapter 5 to
customization.
page 2-3 and Chapter 5 to Chapter 8,
Chapter 8
according to the type of session.
according to the
type of session.
DCAF
According to the type of session, see
Not applicable.
customization.
Chapter 5 to Chapter 8.
TCP/IP
See Chapter 4.
Done by IBM
customization.
representative at
installation.
CCM definitions.
Not applicable.
Available for
APPN sessions
only. See
Chapter 8.
Opening a
See Chapter 3, "Using DCAF to Remotely
Not applicable.
session.
Log On to the Service Processor."
Closing a session.
See Chapter 3, "Using DCAF to Remotely
Use DCAF
Log On to the Service Processor."
hotkeys
[G!][I] .
For more information, see the DCAF: Installation and Configuration Guide,
SH19-4068, that comes with DCAF.
Before starting the installation process, make sure that you have the workstation
already installed and running OS/2 (see "Minimum Workstation (Remote Console)
Configuration" on page 1-4).
© Copyright IBM Corp. 1989, 1998
2-1