Connecting A Dvd Player With Colorstream; (Component Video) And A Vcr - Toshiba 50HPX95 Owner's Manual
Integrated high definition plasma television
Hide thumbs
Also See for 50HPX95:
- Specifications (2 pages) ,
- Owner's manual (144 pages) ,
- Service manual (61 pages)
Table of Contents
Advertisement
Connecting a DVD player with ColorStream
Your TV has ColorStream
®
(component video) inputs.
You will need:
one signal splitter
three coaxial cables
two sets of standard A/V cables
• For better picture performance, if your VCR has S-video, use an
S-video cable (plus the audio cables) instead of the standard
video cable. However, do not connect both types of video cables
to VIDEO 1 (or VIDEO 2) at the same time or the picture
performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV
(VIDEO 1) to your VCR's audio out terminal using the white
audio cable only.
one pair of standard audio cables
one set of component video cables
• You can connect the component video cables (plus audio
cables) from the DVD player to either set of ColorStream
terminals on the TV (HD-1 or HD-2). The ColorStream HD-1
and HD-2 terminals can be used with Progressive (480p,
720p) and Interlaced (480i, 1080i) scan systems. A 1080i
signal will provide the best picture performance.
• If your DVD player does not have component video, see page
19. If your DVD player has HDMI video, see page 22.
To view antenna or Cable channels:
Select the ANT 1 video input source on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD-1
video input source on the TV.*
To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input
source on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to
record. Select the ColorStream HD-1 video input source
on the TV* to view the DVD.
_____________
*
To select the video input source, press INPUT on the remote control
(see page 72). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
20
Chapter 2: Connecting your TV
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate
input mode is selected.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
®
(component video) and a VCR
From antenna or Cable
IN
Signal splitter
OUT
OUT
Stereo VCR
IN from ANT
CH 3
CH 4
OUT to TV
TV back panel
Y
P
P
B
R
S-VIDEO
COMPONENT VIDEO
VIDEO
OUT
OUT
DVD player with component video
To enable the TV Guide On Screen
™
1. Connect the G-LINK
cable according to the
instructions on page 28.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your
VCR owner's manual for details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
™
On Screen
system.
5. See Chapter 7 for details on using the TV Guide
™
On Screen
system.
VIDEO
AUDIO
L
R
IN
OUT
L
R
AUDIO
OUT
L
R
™
recording features:
Advertisement
Table of Contents
