Table of Contents
Advertisement
IBM Ethernet Appliance J36S Getting Started Guide
Compliance Statements for EMC Requirements
Canada
This Class A digital apparatus complies with Canadian ICES-003. Cet appareil
numérique de la classe A est conforme à la norme NMB-003 du Canada.
European Union
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
24
Compliance Statements for EMC Requirements
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the device in the rack.
When installing the device, do not use a ramp inclined more than 10 degrees.
Manually installing the device is a two person lift process. Before lifting the
chassis, remove components as described in the IBM Ethernet Appliance J36S
Hardware Guide. To prevent injury, keep your back straight and lift with your
legs, not your back.
Do not attempt to lift the chassis by the handles on the power supplies or on the
Common Form-factor Modules (CFMs).
The device should be mounted at the bottom of the rack if it is the only unit in
the rack.
When mounting the device in a partially filled rack, load the rack from the bottom
to the top with the heaviest component at the bottom of the rack.
When removing or installing an electrical component, always place it
component-side up on a flat antistatic surface or in an electrostatic bag.
When you install the device, always make the ground connection first and
disconnect it last.
Wire the DC power supply using the appropriate lugs. When connecting power,
the proper wiring sequence is ground to ground, +RTN to +RTN, then –48 V
to –48 V. When disconnecting power, the proper wiring sequence is –48 V to
–48 V, +RTN to +RTN, then ground to ground. Always connect the ground wire
first and disconnect it last.
Do not work on the system or connect or disconnect cables during electrical
storms.
Before working on equipment that is connected to power lines, remove jewelry,
including rings, necklaces, and watches. Metal objects heat up when connected
to power and ground and can cause serious burns or become welded to the
terminals.
Proper clothing and gloves must be worn while installing this device.
Failure to observe these safety warnings can result in serious physical injury.
Advertisement
Table of Contents
