Table of Contents
Advertisement
Reinstall Components
1.
2.
4.
NOTE: Make sure that all empty slots are covered with blank panels before operating
the device.
Step 4: Connect the External Devices and IOC Cables
To connect external devices and IOC cables:
Figure 12: Connect External Devices and IOC Cables
Connect to a Network for Out-of-Band Management
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see the IBM Ethernet Appliance J36S Hardware Guide.
Slide each component into the chassis evenly so that it does not become stuck
or damaged.
Tighten the captive screws or lock any levers for each component installed.
Connect to a Network for Out-of-Band Management on page 13
Connect a Management Console on page 14
Connect the IOC Cables on page 14
RE CONS OLE
ALAR M
0
SCB FRON T
0
PWR
HA REAR
1
FAN
1
Plug one end of the RJ-45 Ethernet cable into the
Switch Fabric Board (SFB).
Step 4: Connect the External Devices and IOC Cables
RE ETHERNET 0
Step 4: Connect the External Devices and IOC Cables
port on the
13
Advertisement
Table of Contents
