Advertisement
Quick Links
THE MINI PUMPS HAVE A NUMBER OF FEATURES WHICH MAKE THEM VERSATILE.
⅜" OR ½" INSIDE DIAMETER TUBING MAY BE CONNECTED TO THE OUTLET, IN
CONJUNCTION WITH THE FLOW CONTROL, IT IS POSSIBLE TO DIRECT AND
ADJUST THE FLOW OF WATER. THIS CAN BE USEFUL IN CONTROLLING SPRAY
AND SPLASHING IN FOUNTAINS AND STATUARY.
IN COMBINATION AQUARIUMS/TERRARIUMS THE USE OF TUBING CAN BE
HELPFUL IN CREATING A WATERFALL AND DISTRIBUTING THE WATER AWAY FROM
THE PUMP AREA.
THE HOUSING SHOULD OCCASIONALLY BE REMOVED TO CLEAN AND INSPECT
THE IMPELLER ASSEMBLY. THE IMPELLER IS THE ONLY SERVICEABLE ITEM AND
CAN BE PULLED OUT OF THE BODY. DO NOT TAKE THE IMPELLER APART. IF IT IS
WORN OR BROKEN THE ENTIRE IMPELLER ASSEMBLY SHOULD BE REPLACED. THIS
WILL RESTORE THE PUMP TO ORIGINAL CAPACITY. PUMPS TAKEN OUT OF SER-
VICE FOR AN EXTENDED PERIOD WITH FLUID INSIDE RUN THE RISK OF FORMING
A CRUST WHICH MAY PREVENT SUBSEQUENT STARTING. SALTWATER SHOULD BE
FLUSHED OUT WITH FRESH WATER. ALWAYS CHECK CORD FOR SHARP BENDS
WHICH CAN CAUSE PREMATURE CRACKING. DO NOT USE POWER CORD TO
LIFT OR MOVE PUMP.
ALWAYS USE A PROPERLY GROUNDED OUTLET. DO NOT IMMERSE PLUG IN WATER. DO NOT REACH INTO WA-
TER TO REMOVE PLUG. TURN OFF CIRCUIT FIRST. A "DRIP LOOP" SHOULD BE PROVIDED. THE "DRIP LOOP" IS A
LOOP IN THE CORD BELOW THE LEVEL OF THE RECEPTACLE OR PLUG THAT PREVENTS WATER FROM TRAVELING
ALONG THE CORD. THE NATIONAL ELECTRIC CODE REQUIRES THAT A GROUND FAULT CIRCUIT INTERRUPTER
(GFCI) BE INSTALLED IN THE BRANCH CIRCUIT SUPPLYING FOUNTAIN OR POND EQUIPMENT.
CAN SUPPLY GFCI UNITS. NEVER REMOVE GROUND PIN FROM PLUG.
WARNING: FOR YOUR PROTECTION ALWAYS UNPLUG THE UNIT FROM ITS POWER SOURCE BEFORE INSTALLING
OR SERVICING. SHOULD THE UNIT APPEAR TO BE NOT WORKING DO NOT REACH, REMOVE OR DISASSEMBLE
UNIT BEFORE YOU DISCONNECT POWER.
THE PUMP IS INTENDED TO PUMP WATER ONLY. IT CANNOT BE USED TO PUMP OILS, SOLVENTS, OR GASOLINE.
CAUTION: PONDS CAN BE DANGEROUS TO SMALL CHILDREN.
E.G. DANNER MFG. INC. WILL REPAIR OR REPLACE ANY UNIT FOUND TO BE DEFECTIVE WITHIN ONE YEAR OF
ORIGINAL PURCHASE. CUTTING OR ALTERING CORD, REMOVING OR DEFACING PRODUCT LABELS VOIDS
ANY WARRANTY CONSIDERATION. FOR WARRANTY REPAIR RETURN ONLY THE PART THAT IS DEFECTIVE TO
OUR FACTORY. PLEASE INCLUDE A DATED PROOF OF PURCHASE AND $5.00 FOR POSTAGE AND HANDLING.
DAMAGES OR INJURIES RESULTING FROM NEGLIGENCE, SHIPPING, HANDLING, IMPROPER INSTALLATION,
MAINTENANCE OR MISUSE OF THE PRODUCT ARE NOT COVERED BY WARRANTY. THIS WARRANTY GIVES YOU
SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
TO VALIDATE THIS WARRANTY KEEP YOUR PROOF OF PURCHASE (COPY OF SALES RECEIPT),
PAGE ONE
CARE AND OPERATING INSTRUCTIONS FOR
BARREL KIT (ITEM # 02160), 140 FOUNTAIN FILTER KIT (ITEM #02272)
FEATURES
SERVICE AND MAINTENANCE
ELECTRICAL PRECAUTIONS
NEVER LEAVE CHILDREN UNSUPERVISED NEAR A POND.
LIMITED WARRANTY
MINI MAG WITH OPTIONAL
WRAP AROUND FILTER AND
AQUA BELL FOUNTAIN
YOUR DEALER
Advertisement
Related Manuals for DANNER MFG 02160
Summary of Contents for DANNER MFG 02160
- Page 1 NEVER LEAVE CHILDREN UNSUPERVISED NEAR A POND. LIMITED WARRANTY E.G. DANNER MFG. INC. WILL REPAIR OR REPLACE ANY UNIT FOUND TO BE DEFECTIVE WITHIN ONE YEAR OF ORIGINAL PURCHASE. CUTTING OR ALTERING CORD, REMOVING OR DEFACING PRODUCT LABELS VOIDS ANY WARRANTY CONSIDERATION. FOR WARRANTY REPAIR RETURN ONLY THE PART THAT IS DEFECTIVE TO OUR FACTORY.
- Page 2 BELL SHAPE LARGE FOAM MODEL ASSEMBLY ( 3 PACK ) PREFILTER COVER FOUNTAIN BLOCK 12655 12605 12635 02089 12600 MINI MAG 1.5 DANNER MFG. INC. 160 OVAL DRIVE, ISLANDIA, NEW YORK 11749 VISIT OUR WEB SITE: WWW.PONDMASTER.COM PAGE TWO C\PUB\INST\MINIMAG 1.5-1.9\7-11\ZG151...