Related Manuals for Sony HKSR-5803HQ
Summary of Contents for Sony HKSR-5803HQ
- Page 1 RGB SQ PROCESSOR BOARD HKSR-5803SQ ADVANCED HQ PROCESSOR BOARD HKSR-5803HQ INSTALLATION MANUAL 1st Edition...
- Page 2 ! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
-
Page 3: Section 1 Installation
. SQ-20 Board . Hexagonal support 7 mm (4 pcs) . PSW2.6 x 5.8 (8 pcs) . Installation manual HKSR-5803HQ is composed of the following items: . DLP-27 Board . Hexagonal support 7 mm (4 pcs) . PSW2.6 x 5.8 (8 pcs) . -
Page 4: Installation Procedure
1-3. Installation Procedure 1. Turn off the power of the VTR. 2. Fully loosen the two fixing screws, and then slide the two knobs on the upper lid (front) assembly each to the inside. (Move the knobs to the outside to fix the upper lid (front) assembly.) 3. - Page 5 6. Remove the six screws to detach the shield plate from the HPR-22 board. Shield plate 2.6 x 6 PSW2.6 x 6 HPR-22 board 7. Attach four 7 mm hexagonal supports (accessory) to the HPR-22 board with four screws (accessory). 8.
- Page 6 The OPTION INFORMATION menu appears. DIAG HPR-22 board 3. Check that “INSTALLED (SQ)” (HKSR-5803SQ) or “INSTALLED (HQ)” (HKSR-5803HQ) is displayed for the HKSR-5803 board. For more information on the maintenance mode, refer to Section 3 of the VTR Maintenance Manual Volume 1.
- Page 7 The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
- Page 8 HKSR-5803SQ (SY) Printed in Japan Sony Corporation HKSR-5803HQ (SY) J, E 2007. 10 08 3-286-478-01 ©2007...