Table of Contents
Advertisement
To set transition rates with the Flexi Pad control block
To set transition rates from menus
70
Preparing Transitions
2
3,4
1
Transition rate display
1.5 M/E panel
1
In the Flexi Pad control block, press the [TRANS RATE] mode selection
button, lighting it.
The Flexi Pad control block enters transition rate input mode.
2
Select the target of the setting with the delegation selection buttons.
• Press [M/E] to set for the M/E bank.
• Press [PP/ALL] to set for the PGM/PST bank (when using the 1.5M/E
panel).
3
Enter the transition rate as a number of frames. (The setting range is 0 to
999.)
4
Press the [ENTR] button.
This confirms the input. The transition rate appears beneath the fader lever
in the transition control block.
1
From the top menu, select Misc >Transition.
The Transition menu appears.
2
3,4
1
Transition rate display
1 M/E panel
- Quick Links:
- System Features
- Introduction
- Chapter 1 Overview
Hide quick links:
Advertisement
Table of Contents
