Table of Contents
Advertisement
Cleaning the image sensor
If dust or debris enters the camera and lands on the image sensor (the part
that acts as the film), it may appear on the photo image, depending on the
shooting environment. If there is dust on the image sensor, use a
commercially available blower and clean the image sensor following the
steps below. You can easily clean the image sensor using only the blower
and the anti-dust function.
Notes
• Cleaning can be performed only when the battery level is
battery icons) or more. Low battery power during cleaning can cause damage to the
shutter. The cleaning should be completed quickly. The use of an AC-PW10AM AC
Adaptor (sold separately) is recommended.
• Do not use a spray blower because it may scatter water droplets inside the camera
body.
1
Confirm that the battery is fully charged (page 18).
2
Press the MENU button, then
select
3 with b/B on the
controller.
3
Select [Cleaning mode] with v/V,
then press the center of the
controller.
The message "After cleaning, turn
camera off. Continue?" appears.
4
Select [OK] with v, and press the center of the controller.
After the image sensor vibrates for a short time, the mirror in front is lifted.
5
Detach the lens (page 21).
(three remaining
MENU button
33
- Quick Links:
- Preparing the Battery Pack
Hide quick links:
Advertisement
Table of Contents
