Table of Contents
Advertisement
Chapter 1, Basic Operation
• Flow rates may be easily set by using the DigiCal 5
Primary Calibrator (part no. 655101) or an equivalent
device (FIGURE 1-5)
9. Adjust the needle valve to obtain the desired flow rate
through the Tube.
10. Repeat steps 6, 7, and 8 for the other Tube.
NOTE:
11. Install either the large or small Tube Protector.
12. Sampling may begin immediately, or the pump may be
turned off until sampling is to be started.
Setting the Flow Rate with the DigiCal 5 Primary Calibrator
1-6
The total flow must not exceed 500 ml per
minute (ml/min).
Figure 1-5.
Operation Manual
FLOW RATE
LOW
BATT
On
Off
GEMINI Twin-Port Sampler
Advertisement
Table of Contents
