Pillow Speaker Setup; Troubleshooting; General Troubleshooting - LG 22LG3DDH Owner's Manual
Hide thumbs
Also See for 22LG3DDH:
- Owner's manual (93 pages) ,
- Setup manual (53 pages) ,
- Service manual (36 pages)
Table of Contents
Advertisement
Troubleshooting
General Troubleshooting (Some Quick and Easy Tips for Resolving Problems)
Symptom
Installation
Cannot direct enter
channel number.
No channels present
after setup.
Power
No power.
Display Panel Picture
No picture.
Erratic Operation
Installer Menu setup.
Installer Remote
Remote doesn't work.
Picture Reception
Normal picture,
poor or no sound.
Note: For other problems not caused by the TV, refer to the other devices' operating guide(s).
46
Possible Cause(s)
(TV in Stand-alone Mode) Installer
Menu item 028 CH. OVERIDE is set
to 0, i.e., disabled (recommended
setting) and/or Channel Access was
denied in Express Script.
Auto Tuning (Channel Search) not
run.
See troubleshooting flow chart on following page.
Display panel is turned off.
Antenna/cable not connected.
Connections incorrect.
MPI not connected.
Encrypted program.
Wrong tuning band.
Wrong Installer Menu settings.
Remote not in TV Mode.
Not aimed at IR remote sensor.
Remote too far from IR sensor.
MPI not connected.
IR path to TV's receiver obstructed.
Weak batteries.
Wrong battery polarity.
Too much light in room.
Bed Switch set to wrong bed.
Wrong Installer Remote.
Audio muted.
Broadcast problem.
Pillow Speaker Switch setting.
Possible Solution(s)
If the channel lineup is locked, only channels that are active in
the TV's channel lineup can be selected. Set 028 CH. OVERIDE
to 1 to allow access for direct keypad entry to all channels.
Refer to Express Script or Custom Master TV Setup procedure,
as appropriate. Auto Tuning must be run in order for the channel
lineup to be populated. Note for Express Script: You must select
"Execute Auto Search" in the Auto Search screen to run the
search (see page 10). To re-activate the Express Script, set
Installer Menu item 117 FACT DEFAULT to 001.
• Turn TV ON.
• Power failure?
Connect antenna/cable signal to TV.
Check connections on TV.
If applicable, connect MPI cable to MPI device.
Try another channel.
Adjust Installer Menu settings.
Adjust Installer Menu settings as required.
Use MODE key to select "TV"; puts remote into TV Mode.
Point remote at TV's IR receiver on TV.
Move remote closer to TV's IR receiver or darken room.
If applicable, connect MPI cable to MPI device.
Remove obstructions.
Replace batteries.
Check that "+" and "-" match in battery compartment.
Dim room light.
Set Bed Switch or update Installer Menu, as necessary.
Requires compatible Installer Remote. Contact your LG dealer.
Press MUTE or use Volume Up key to increase sound level.
Try a different channel.
Check Pillow Speaker Switch setting. If set to Normal, sound will
be heard on TV speakers. If set to Pillow, sound will be heard on
pillow speaker.
206-4190
- Quick Links:
- Other A/V Source Setup
- Input List
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
