Table of Contents
Advertisement
Before You Begin
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Before You Begin
Before installing and connecting a Cisco 2010 CGR router, read the safety warnings and gather the
following tools and equipment:
•
•
•
•
In addition, depending on the type of modules you plan to use, you might need the following equipment
to connect a port to an external network:
•
•
•
•
•
•
•
Sites with ambient temperatures consistently above 25 degrees C (77 degrees F) and with potentially
Caution
high levels of dust or debris may require periodic preventative maintenance cleaning.
Unpacking the Router
Do not unpack the router until you are ready to install it. If the final installation site will not be ready
for some time, keep the chassis in its shipping container to prevent accidental damage. When you are
ready to install the router, proceed with unpacking it.
The router, accessory kit, publications, and any optional equipment you ordered may be shipped in more
than one container. When you unpack the containers, check the packing list to ensure that you received
all of the items on the list.
Installing the Router in a Rack
The Cisco 2010 CGR can only be mounted in a rack.
Cisco Connected Grid Routers 2010 Hardware Installation Guide
3-4
ESD-preventive cord and wrist strap
Number 2 Phillips screwdriver
Flat-blade screwdrivers: small, 3/16-in. (4 to 5 mm) and medium, 1/4-in. (6 to 7 mm)
To install or remove GRWICs
–
To remove the cover, if you are upgrading memory or other components
–
Screws that fit your rack
Cables for connection to the WAN and LAN ports (dependent on configuration).
For more information on cable specifications, see
Note
Specifications
on www.cisco.com.
Ethernet hub or PC with a network interface card for connection to an Ethernet (LAN) port.
Console terminal (an ASCII terminal or a PC running HyperTerminal or similar terminal emulation
software) configured for 9600 baud, 8 data bits, 1 stop bit, no flow control, and no parity.
Modem for connection to the auxiliary port for remote administrative access (optional).
Data service unit (DSU) or channel service unit/data service unit (CSU/DSU) as appropriate for
serial interfaces.
External CSU for any CT1/PRI modules without a built-in CSU.
NT1 device for ISDN BRI S/T interfaces (if not supplied by your service provider).
Chapter 3
Installing and Connecting the Router
Cisco Modular Access Router Cable
OL-21559-01
Advertisement
Table of Contents
