Vtp Version - Cisco Nexus 5500 Series Command Reference Manual
Nx-os layer 2 interfaces command reference
Hide thumbs
Also See for Nexus 5500 Series:
- Hardware installation manual (142 pages) ,
- Command reference manual (378 pages) ,
- Configuration manual (160 pages)
Table of Contents
Advertisement
vtp version
vtp version
To configure the administrative domain to a VLAN Trunking Protocol (VTP) version, use the vtp
version command. To revert to the default version, use the no form of this command.
Syntax Description
version
Command Default
Version 1 enabled
Version 2 disabled
Command Modes
Global configuration mode
Command History
Release
5.2(1)N1(1)
Usage Guidelines
Before you use this command, you must enable VTP on the switch by using the feature vtp command.
If you enable VTP, you must configure either version 1 or version 2. If you are using VTP in a Token
Ring environment, you must use version 2.
Examples
This example shows how to enable VTP version 2 for Token Ring VLANs:
switch(config)# vtp version 2
switch(config)#
Related Commands
Command
feature vtp
show vtp status
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1454
vtp version version
no vtp version
VTP version. The range is from 1 to 2.
Modification
This command we introduced.
Description
Enables VTP on the switch.
Displays VTP information.
Chapter
V Commands
OL-27880-02
- Quick Links:
- Show Vlan Dot1Q Tag Native
Hide quick links:
Advertisement
Table of Contents
