Table of Contents
Advertisement
Quick Links
INSTALLATION AND OPERATING INSTRUCTIONS
Covers Models:
PA5120E Mixer Amplifier
PA5200C Twin Cassette Deck
WARNING: THIS APPLIANCE MUST
BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Green and Yellow: Earth
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings identifying the
terminals in your plug proceed as follows:
The wire which is coloured green and yellow must be connected
to the terminal which is marked by the letter E or by the safety
earth symbol or coloured green and yellow. The wire which is
coloured blue must be connected to the terminal which is
marked with the letter N or coloured black. The wire which is
coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
If a 13 Amp (B.S. 1363) plug or any other type of plug is used, a
5 Amp fuse must be fitted either in the plug or at the distribution
board.
Mixer Amplifiers PA5060E and PA5120E
REAR PANEL
220 - 240V~50/60Hz
MODEL NO.
PA5120E
RATED OUTPUT 120W RMS
MADE IN TAIWAN
MUSIC/SPEECH
SPEECH ONLY
250V 2.5A
24V DC
1
2
3
1.
24V DC Connector
2.
Mains Connector
3.
Loudspeaker Connector
4.
Booster Out Phono Socket
5.
Booster Out DIn Socket
6.
Aux 3 Input Socket
7.
Mic 5 Input Socket
8.
Aux 2 Input Socket
9.
Mic 4 Input Socket
10.
Aux 1 Input Socket
11.
Mic 3 Input Socket
12.
Mic 2 Input Socket
13.
Mic 2 Priority Socket
PA5060E Mixer Amplifier
PA5200CT Tuner with blank slot for a Cassette Deck or Tuner
(E)
(N)
(L)
BOOSTER OUT
AUX 3 MIC5
AUX 2
MIC4
AUX 1
MIC3
4
5
6
7
8
9
10
11
PA5000 SERIES TWO ZONE
PUBLIC ADDRESS AMPLIFIERS
PAB5120E Booster Amplifier
GENERAL INSTALLATION
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT
AVOID
ALWAYS
ALWAYS
ENSURE
ENSURE
REMOVE
FRONT PANEL
MIC1
OVER-
LOAD
17
12 13 14 15
16
14.
Mic 1 Input Socket
15.
Mic 1 Priority Socket
16.
Input Overload Indicator
17.
Mic 1 Level Control
18.
Mic 2 Level Control
19.
Mic 3/Aux 1 Level Control
20.
Mic 4/Aux 2 Level Control
21.
Mic 5/Aux 3 Level Control
22.
Bass Control
23.
Treble Control
24.
Master Level Control
25.
Power On/Off Switch
26.
Power On Indicator
1
PAB5240E Booster Amplifier
use low impedance loudspeakers.
run microphone cables near mains, data,
telephone or 100V line cables.
run 100V line cables near data, telephone or
other low voltage cables.
exceed 90% of the amplifiers output power
when using 100V line (speech only).
exceed 70% of the amplifiers output power
when using 100V line
(high level background music).
use re-entrant horn loudspeakers for
background music unless the loudspeaker has
been specifically designed for this purpose.
jointing the microphone cable, when this is
unavoidable make sure a good screened
connector is used, e.g. XLR.
use a balanced or floating low impedance
microphone terminating into a balanced input
on long microphone cable runs.
use a mains grade double insulated cable for
the loudspeaker cable runs.
that all loudspeakers are in-phase.
that there are no short circuits on the
loudspeaker line before connecting to the
amplifier.
the top cabinet when fitting the 19" rack ears
supplied (these are fitted using the existing
screw holes and screws from the top cabinet).
MIC2
MIC3/AUX1
MIC4/AUX2
MIC5/AUX3
BASS
18
19
20
21
22
GB
TREBLE
MASTER
23
24
25
26
Advertisement
Table of Contents
Related Manuals for Eagle PA5060E
Summary of Contents for Eagle PA5060E
-
Page 1: General Installation
REMOVE the top cabinet when fitting the 19” rack ears supplied (these are fitted using the existing screw holes and screws from the top cabinet). Mixer Amplifiers PA5060E and PA5120E REAR PANEL FRONT PANEL 220 - 240V~50/60Hz MODEL NO. -
Page 2: Rear Panel
Booster Amplifiers PAB5120E and PAB5240E REAR PANEL FRONT PANEL 220 - 240V~50/60Hz MODEL NO. PA5120E RATED OUTPUT 120W RMS MADE IN TAIWAN OVERLOAD MUSIC/SPEECH SPEECH ONLY 250V 2.5A 24V DC Battery Connector Input Socket (Phono) Mains Connector Input Socket (DIN) Loudspeaker Connector Sensitivity Selector Volume Control... -
Page 3: Common Problems
If you wish to use an unbalanced microphone, ensure the microphone is fitted with a standard 1/4” Mono Jack Plug, when this is inserted into the microphone input socket, the input will automatically become unbalanced. Phantom Power A new feature has been added to the PA5000 series amplifiers. This feature will enable phantom powering of Electret Condenser Microphones. The phantom power can be turned on or off by moving the shorting pliug on the link pins adjacent to each input. -
Page 4: Tuner Module
Specifications Mixer Amplfiers Specifications for Booster Amplifiers Model PA5060E PA5120E Model PAB5120E PAB5240E Power supply AC 220 - 240V AC220 - 240V Power supply AC 220 - 240V 50Hz AC 220 - 240V 50Hz DC 24V DC24V DC 24V DC24V... - Page 5 PA5200C REAR PANEL PA5200C FRONT PANEL LOGIC EJECT EJECT POWER PROGRAM PROGRAM AUTO-REVERSE AUTO-REVERSE Background Music Cassette Player Background Music Cassette Player DC Connector Cassette Decks Mains Connector Power on Indicator Audio Out Socket Mode Selector Switch Audio In Socket Mains on/off switch Logic Out Socket Logic In Socket...