Table of Contents
Advertisement
Available languages
Available languages
OPERATION
7. Enter the pass code and press the S/S button.
The S/S button will flash one slow green blink
if the code is accepted and will change to a
rapid green blink.
If the S/S button has accepted the code but
does not stay lit with a rapid green blink, see
Ignition System Faults.
When the S/S button displays a rapid green
blink, press and release the button once more
to start the engine.
Allow the engine to run at a moderate speed,
approximately mid throttle, for a short time
before use.
NOTE: For the first start after the unit has been
idle for an extended period, or has been refueled
after being run out of gas, the engine may require
an extended start attempt to reprime the fuel
system. Press and hold down the S/S switch for
three seconds and then release. This will prompt
the engine starter to attempt starting the engine
for up to ten seconds (instead of the normal five
seconds), allowing time for fuel to be pulled into
the engine.
Ignition System Faults
The SmartSwitch Ignition is programmed to warn
when any part of the safety system is not being
followed and will not allow the unit to be started
until all system faults are resolved.
The blade switch fault light will blink if the blade
control switch has not been disengaged (down
position) or is disconnected.
The motion control fault light will blink if the
motion control levers are not in the neutral (outer)
position.
Running
1. Release the park brake by pulling the steering
/ park brake controls inwards to the neutral
position at the same time.
NOTE: The mower is equipped with an
operator presence system. If the operator
tries to leave the seat with the engine running,
without first setting the park brake, the engine
will shut off.
2. Lower the mower deck to the desired cutting
height.
19
- Quick Links:
- Engine Oil
- Troubleshooting
- Schematic
Hide quick links:
Advertisement
Table of Contents
