Maintenance; Optional Accessories; Replacing Carbon Brushes - Makita 3708 Instruction Manual
Trimmer
Hide thumbs
Also See for 3708:
- Instruction manual (64 pages) ,
- Specifications (2 pages) ,
- Instruction manual (33 pages)
Table of Contents
Advertisement
1
2
3
4
002012
Install the trimmer guide on the tool base with the clamp
screw (A). Loosen the clamp screw (B) and adjust the
distance between the bit and the trimmer guide by
turning the adjusting screw (1 mm per turn). At the
desired distance, tighten the clamp screw (B) to secure
the trimmer guide in place.
When cutting, move the tool with the guide roller riding
the side of the workpiece.
1
001998
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1. Clamp screw (A)
2. Adjusting screw
3. Clamp screw (B)
4. Trimmer guide
5. Wing bolt
5
1. Workpiece
2
2. Bit
3. Guide roller
3
1. Limit mark
1
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
001999
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide assembly
•
Trimmer guide assembly
•
Trimmer base assembly (For chamfering with
•
straight bit)
Trimmer shoe
•
Templet guide
•
Collet cone 6 mm
•
Collet cone 6.35 mm (1/4")
•
Wrench 10
•
Wrench 17
•
9
1. Screwdriver
2. Brush holder
cap
or
attachments
Only use
accessory or
are
Advertisement
Table of Contents
