IBM eServer 232 xSeries Installation Manual page 28
Hide thumbs
Also See for eServer 232 xSeries:
- Hardware maintenance manual (178 pages) ,
- User reference manual (174 pages)
Table of Contents
Advertisement
that will enable you to install up to three power supplies, which enables redundancy
and will make the power supplies hot-swappable. Each power supply has two status
indicators; see the following illustration for information about the status indicators and
power-supply bay locations.
Note: The illustrations in this document might differ slightly from your hardware.
Filler panel
Two 250-watt configuration
Note: The following description refers to the 250-watt configuration figure.
Filler panel
Power supply bay 1
Power supply bay 2
Power supply bay 3
16
IBM xSeries 232: Installation Guide
Power supply
bay 3
Power supply
bay 2
Power supply
bay 1
DC power
LED (green)
AC power
LED (green)
To maintain proper airflow, keep the filler panel in place on empty power-
supply bays as shown.
Your server comes with this power supply installed in this bay. LED PS1 on
the system board diagnostics panel refers to this power supply. See the
User's Reference on the xSeries Documentation CD for the location of the PS
1 LED.
Your server comes with this power supply installed in this bay. LED PS2 on
the system board diagnostics panel refers to this power supply. See the
User's Reference on the xSeries Documentation CD for the location of the
PS2 LED.
If you install an optional power supply in this bay, LED PS3 on the system
board diagnostics panel refers to this power supply. See the User's Reference
on the xSeries Documentation CD for the location of the PS3 LED.
Power supply
DC
AC
GOOD
GOOD
385-watt configuration
DC power
LED (green)
AC power
LED (green)
Advertisement
Table of Contents
