Download Print this page

Plunge Cutting - Panasonic EY4541 Operating Instructions Manual

Cordless jigsaw

Hide thumbs Also See for EY4541:

Table of Contents

• When cutting complex shapes such

as shapes with many small curves,

reduce the cutting speed and the

turning speed.

Plunge cutting

1. Make a drill hole in the section to be

plunge cut in order to let the blade

pass through.

2. Insert the blade into a hole without

touching the workpiece, and then

turn on the power switch.

3. Cut along the marked line.

Using a rip fence (EY9X011E)

(Available as an accessory,

not included)

A rip fence can be used for cutting

parallel lines and for cutting circles

and arcs.

Installing the rip fence

1. Loosen the rip fence fixing screw.

2. Pass the rip fence through the mount.

3. Adjust the cutting position and then

tighten the fixing screw.

Cutting at the same width

1. Place the base onto the workpiece

so that the edge of the rip fence

and workpiece are put together.

2. Without letting the blade touch the

workpiece, turn on the power switch.

3. Face the rip fence firmly to the

workpiece to cut parallel line.

- 15 -

Table of Contents