Table of Contents
Advertisement
Table 7. Service Processor Error Codes (continued)
Error Code
Description
4066 00A6
Scan interface basic assurance tests
detected no usable memory
4066 00A7
Scan interface basic assurance tests
detected hardware problem
4066 00B0
Scan interface basic assurance tests
detected bus controller lock-unlock
failure
4066 00B1
Scan interface basic assurance tests
detected bus controller failure
4066 00B7
Scan interface basic assurance tests
detected insufficient hardware
resources to continue IPL
4066 0100
Scan interface basic assurance tests
detected memory riser card fault
4066 0101
Scan interface basic assurance tests
detected memory DIMM fault
4066 0102
Scan interface basic assurance tests
detected memory DIMM fault
4066 0103
Scan interface basic assurance tests
detected memory DIMM fault
4066 0104
Scan interface basic assurance tests
detected memory DIMM fault
4066 010D
Scan interface basic assurance tests
detected memory DIMM fault
4066 0111
Scan interface basic assurance tests
detected memory DIMM fault
4066 0112
Scan interface basic assurance tests
detected memory DIMM fault
Action/ Possible Failing FRU
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 266 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2
Memory DIMM Location: P1-M2.15
Memory DIMM Location: P1-M2.1
Memory DIMM Location: P1-M2.16
Memory DIMM Location: P1-M2.2
Memory DIMM Location: P1-M2.1 x4
Memory DIMM Location: P1-M2.13
Memory DIMM Location: P1-M2.3
Chapter 5. Error Code to FRU Index
139
Advertisement
Table of Contents
