Setting The Link Speed/Duplex Mode; Setting Wake On Lan - Fujitsu ScanSnap N1800 Operator's Manual

Network scanner

Hide thumbs Also See for ScanSnap N1800:

Table of Contents

If connection to LDAP server is not possible, try the following steps:

1. Disconnect the LAN cable.

2. Press the [Shutdown] button on the LCD touch panel to turn the scanner

3. Press the power button to start the scanner with the LAN cable

4. Enter a non-duplicated IP address.

5. Re-connect the LAN cable to the scanner.

If the DHCP server cannot be reached when DHCP is set to [On], the IP

address is set to "169.254.XXX.YYY" (where XXX and YYY are arbitrary

values between 0 and 255).

■ Setting the Link Speed/Duplex Mode

While the network operating status is correct, if the network is not communicating

properly, change the Link Speed/Duplex Mode settings.

1. On the [Network Status] window, change [Link speed/Duplex mode] to a

2. Press the [OK] button.

The Link Speed/Duplex Mode setting is changed.

Set whether or not to enable Wake On LAN to turn the scanner on/off via the network

1. For [Wake On LAN] on the [Network Status] window, select whether to

enable Wake On LAN.

2. Press the [OK] button.

Wake On LAN is set.

disconnected.