Installing And Removing The Bezel On The Ds300 Model 1701-1Rl - IBM TotalStorage DS300 Hardware Installation And User's Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

Installing and removing the bezel on the DS300 Model 1701-1RL

Note: Before installing the bezel on the storage subsystem, install it in the rack.

For more information, see the Rack Mounting Instructions that come with the

storage subsystem.

Complete the following steps to install the storage subsystem bezel:

1. Make sure that the EMI panel on the left side of the storage subsystem remains

Figure 32. Installing the bezel on the DS300 Model 1701-1RL

2. Place the 7-hard disk drive cover insert into the left side of the bezel. Make sure

3. Position the bezel directly in front of the storage subsystem.

4. Insert the three tabs on the bottom of the bezel into the matching holes on the

5. Rotate the top of the bezel toward the storage subsystem until the two tabs at

6. To remove the bezel:

a. Press in on the blue tab on the top outside edge of both sides of the bezel,

and pull the top of the bezel slightly away from the storage subsystem.

b. Pull the bezel up to release the three tabs at the bottom edge of the bezel.

Store the bezel in a safe place.

in place for proper cooling.

EMI panel

7-disk drive cover

orientation tabs

that the cover insert tabs are flush with the bezel frame.

storage subsystem chassis.

the top of the bezel snap into place.

a. Press in on the blue tab on the top outside edge on both sides of the bezel,

and pull the top of the bezel slightly away from the storage subsystem.

b. Pull the bezel up to release the three tabs at the bottom edge of the bezel.

Store the bezel in a safe place.

Chapter 5. Installing and replacing components

Table of Contents

Totalstorage ds400