Installing An Sfp Module - IBM TotalStorage DS300 Hardware Installation And User's Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

Installing an SFP module

Complete the following steps to install an SFP module.

Statement 3:

CAUTION:

When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or

transmitters) are installed, note the following:

v Do not remove the covers. Removing the covers of the laser product could

v Use of controls or adjustments or performance of procedures other than

DANGER

Attention:

damage from static electricity. For details about handling static-sensitive devices,

see "Handling static-sensitive devices" on page 41.

1. Read the information in "Handling an SFP module" on page 21.

2. Remove the SFP module from its static-protective package.

3. Remove the protective cap from the SFP module, as shown in Figure 17. Save

Protective cap

Figure 17. Small Form-Factor Pluggable (SFP) module

4. Rotate the SFP module so that the plastic or wire tab is on the bottom; then,

IBM TotalStorage DS300 and DS400: Hardware Installation and User's Guide

result in exposure to hazardous laser radiation. There are no serviceable

parts inside the device.

those specified herein might result in hazardous radiation exposure.

Some laser products contain an embedded Class 3A or Class 3B laser

diode. Note the following.

Laser radiation when open. Do not stare into the beam, do not view directly

with optical instruments, and avoid direct exposure to the beam.

When you handle static-sensitive devices, take precautions to avoid

the protective cap for future use.

Plastic tab

SFP module

insert it into the host connector until it clicks into place. See Figure 18 on page

23.

Table of Contents

Totalstorage ds400