Table of Contents
Advertisement
1.
When the disc tray pops open slightly, wait a moment to make sure the
disc has stopped spinning before pulling the disc tray fully open.
2.
3.
How to remove disc when the disc tray will not open
Pressing the eject button will not open the disc tray when the computer
power is off. If the power is off, you can open the disc tray by inserting a
slender object (about 15 mm) such as a straightened paper clip into the
eject hole near the eject button.
1. Eject hole
Turn off the power before you use the eject hole. If the disc is spinning
when you open the disc tray, the disc could fly off the spindle and cause
injury.
Writable discs
This section describes the types of writable discs. Check the specifications
of your drive to see the types of discs it can write. Use TOSHIBA Disc
Creator and Corel Digital Studio to write compact discs.
CDs
DVDs
User's Manual
To pop the disc tray partially open, press the eject button. Gently pull
the disc tray out until it is fully opened.
The disc extends slightly over the sides of the disc tray so you can
grasp it. Gently lift out the disc.
Push the center of the disc tray to close it. Press gently until it locks
into place.
Figure 3-7 Manual release with the eject hole
CD-R discs can be written only once. The recorded data cannot be
erased or changed.
CD-RW discs including multi speed CD-RW discs, high-speed CD-RW
discs and ultra-speed CD-RW discs can be recorded more than once.
DVD-R, DVD+R, DVD-R DL and DVD+R DL discs can be written only
once. The recorded data cannot be erased or changed.
Satellite P770/P775/P770D/P775D
Φ1.0mm
1
3-10
Hide quick links:
Advertisement
Table of Contents
