Installing An Optical Drive (Desktop Configuration); Installing An Odd In An Hp Z600 Or Z800 Workstation - HP Z600 - Workstation - 6 GB RAM User Manual
Hp z workstation series user guide
Hide thumbs
Also See for Z600 - Workstation - 6 GB RAM:
- Installation manual (12 pages) ,
- Installation (2 pages) ,
- Declaration of conformity (1 page)
Table of Contents
Advertisement
Installing an optical drive (desktop configuration)
1.
Follow the procedures described in
workstation for component installation.
2.
If necessary, remove the blank filler and the EMI filler from the optical bay.
3.
Install the four black metric M3 guide screws into the drive (1).
Figure 10-2
4.
Align the screws with the grooves in the drive bay and gently slide the drive into the casing until it
snaps into place (2).
CAUTION:
to see if it can become disengaged. Failure to properly secure the drive can cause damage to the
drive when moving the workstation.
5.
Connect the power and drive cables to the drive and system board.
Installing an ODD in an HP Z600 or Z800 Workstation
To install an ODD:
1.
Follow the procedures described in
workstation for component installation.
2.
If necessary, lift the optical bay filler tray handle and remove it from the workstation.
ENWW
Preparing for component installation on page 40
Installing the optical drive
Ensure that the optical drive is secure in the workstation chassis by pulling the drive
Preparing for component installation on page 40
Installing an ODD in an HP Z600 or Z800 Workstation
to prepare the
to prepare the
59
Hide quick links:
Advertisement
Table of Contents
