Setting Automatic Hardware Power Management Features; Automatic Power-On Features - IBM NetVista Hardware Maintenance Manual
Hardware maintenence manual for netvista 6838 and 6848 systems
Hide thumbs
Also See for NetVista:
- Hardware maintenance manual (211 pages) ,
- Hardware manual (135 pages) ,
- Guide utilisateur (124 pages)
Table of Contents
Advertisement
v
v
v
Setting Automatic Hardware Power Management features
10. To exit from the Configuration/Setup Utility program, press Esc and follow
Automatic Power-On features
The Automatic Power-On features within the Power Management menu allow you
to enable and disable features that turn on the computer automatically.
v Serial Port A Ring Detect: With this feature set to Enabled and an external
v PCI Modem Ring Detect: With this feature set to Enabled , the computer will
v PCI Wake Up: This feature allow PCI cards that support this capability to wake
76
IBM NetVista Type 6838, 6848: Hardware Maintenance Manual
System Power
– Select On for the computer to remain on.
– Select Off for the computer to shut down.
Processor Speed
Set the microprocessor to be disabled, or to run at 1, 10, 25, or 50 percent of its
internal clock speed.
Display
Set display to be disabled or to be reduced at these power states:
– Standby: Screen is blank, but can be restored immediately when any activity
is detected.
– Suspend: Monitor uses less power than in Standby mode. Screen image is
restored after a few seconds when any activity is detected.
– Off: Monitor power is off. Press Monitor power button to restore power. On
some monitors, you might have to depress the power button twice.
1. Start the Configuration/Setup Utility program (see "Using the
Configuration/Setup Utility program" on page 19).
2. Select Advanced Power Management from the Configuration/Setup Utility
program menu.
3. Select the APM BIOS Mode and be sure it is set to Enabled. If it is not, press
Left Arrow (}) or Right Arrow (Æ) to change the setting.
4. Select Automatic Hardware Power Management.
5. Set Automatic Hardware Power Management to Enabled.
6. Select values for the three categories of power management (system power,
processor speed, and display), as necessary.
7. Set Hard Disk to Enabled or Disabled.
Note: This does not apply to SCSI drives.
8. Press Esc twice to return to the Configuration/Setup Utility program menu.
9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
the instructions on the screen.
modem connected to serial port (COM1), the computer will turn on
automatically when a ring is detected on the modem.
turn on automatically when a ring is detected on the internal modem.
the system.
Advertisement
Table of Contents
