Table of Contents
Advertisement
Note: See "System" on page 108 to determine which components a field service technician should replace.
Error code/symptom
166-070-000 System Management: Failed
(Unable to communicate with RSA. It may
be busy. Run the test again.)
166-198-000 System Management:
Aborted
(Unable to communicate with RSA. It may
be busy. Run the test again.)
166-250-000 System Management: Failed
(I2C cable is disconnected. Reconnect I2C
cable between Remote Supervisor Adapter
and system board.)
166-260-000 System Management: Failed
(Restart RSA error. After restarting, RSA
communication was lost. Unplug and cold
boot to reset RSA.)
166-342-000 System Management: Failed
(RSA adapter BIST indicate failed tests.)
166-400-000 System Management: Failed
(BMC self test result failed tests: x where x
= Flash, RAM, or ROM.)
166-404-001 System Management: Failed
(BMC indicates failure in I2C bus test.)
166-406-001 System Management: Failed
(BMC indicates failure in I2C bus test.)
88
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Flash latest levels of firmware (BIOS, service processor,
diagnostics)
2. Rerun diagnostic test.
3. Correct other error conditions (including failed system management
tests and items logged in Remote Supervisor Adapter II SlimLine
system-error log) and retry.
4. Disconnect all server and option power cords from server, wait 30
seconds, reconnect, and retry.
5. Remote Supervisor Adapter II SlimLine.
1. Run the diagnostic test again.
2. Correct other error conditions and retry. These include other failed
system management tests and items logged in the system-error log
of the optional Remote Supervisor Adapter II SlimLine.
3. Disconnect all server and option power cords from the server, wait
30 seconds, reconnect, and retry.
4. Remote Supervisor Adapter II SlimLine, if installed.
5. System board.
1. Remote Supervisor Adapter II SlimLine.
2. System board.
1. Disconnect all server and option power cords from the server,
wait 30 seconds, reconnect, and retry.
2. Reseat Remote Supervisor Adapter II SlimLine.
3. Remote Supervisor Adapter II SlimLine.
1. Ensure the latest firmware levels for Remote Supervisor
Adapter II SlimLine and BIOS are installed.
2. Disconnect all server and option power cords from server, wait 30
seconds, reconnect, and retry.
3. Remote Supervisor Adapter II SlimLine.
1. Reflash or update firmware for BMC.
2. System board.
1. Disconnect all server and option power cords from the server,
wait 30 seconds, reconnect, and retry.
2. Reflash or update firmware for BMC.
3. Power backplane
4. System board.
1. Disconnect all server and option power cords from the server,
wait 30 seconds, reconnect, and retry.
2. Reflash or update firmware for BMC.
3. SCSI cable.
4. SCSI backplane.
5. System board.
Advertisement
Table of Contents
Troubleshooting
