Table of Contents
Advertisement
Available languages
Available languages
Narrow overlock/ Rolled hemming stitch
The Narrow overlock/Rolled hemming stitch is a
decorative finish for lightweight to midweight
fabrics. It is often used to complete the edge of a
fabric. This stitch is sewn by removing the left
needle and using the 3-thread overlock stitch.
Instructions for both narrow overlock/
Rolled hemming stitches
CAUTION
Turn off the main power and light switch before
removing/ installing a needle.
1. Remove the left needle.
NOTE:
For the recommended thread and needle, see
CHAPTER 4 "Sewing materials, threads, and
needles comparison chart".
2. Thread the machine for a three thread
overlock, using the right needle.
3. Remove the stitch finger <A>.
1 Raise the presser foot lever.
2 Pull all threads toward the back of the
machine.
3 Check to make sure that the thread is no
longer wrapped around the stitch finger.
4 Open the front cover.
5 Turn the hand wheel until the upperlooper
is at its lowest position.
6 Pull the stitch finger to the right and remove
it.
4. Store the removed stitch finger <A> and/or
stitch finger W <B> inside of the bed
extension.
NOTE:
Make sure to install a stitch finger when sewing
regular overlock stitches.
5. Adjust the stitch width adjustment dial up to the
"R" position.
6. Adjust the stitch length.
Set the stitch length adjustment dial to "R to 2"
position (for narrow overlock stitch: R to 2, for
rolled hemming stitch: R).
<A>
<A>
<B>
<A>
<A> Selection mark
3
<A>
<A> Selection mark
25
- Quick Links:
- Table of Contents
- Accessories
Hide quick links:
Advertisement
Chapters
Table of Contents
