Advertisement
You can select and start a new
programme following the cancellation
of Time Delay function.
Time Delay function cannot be set after
the programme starts.
Starting the programme
Close the door of your machine to start it
after selecting the programme and auxiliary
functions.
Your machine performs water softening
depending on the hardness level of
the supply water. Washing time can
change while the programme is running
depending on the ambient temperature
where your machine is installed,
temperature of the supply water and
amount of the dishes.
Pay attention not to open the door of
the machine when it is running. There
may be a rush of vapour when you
open the door of your machine; be
careful.
The machine will remain silent in
pause mode for some time in order to
remove the water from the machine
and on the dishes completely and to
have the water softener cleaned, and
then it will resume running in drying
mode.
Cancelling the programme
Open the door of the product Press
and hold the Programme Selection /
Programme Cancel keys for 3 seconds.
After the 3 - 2 - 1 countdown, 0:01 is
displayed, close the door of the product
and wait for the draining process complete.
Draining is completed in 2 minutes and the
machine gives an audible warning when it
is completed.
There might be residues of detergent
or rinse aid in the machine and/or on
the pieces being washed depending
on the step the programme you have
cancelled was in.
Salt indicator (
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
Adjusting the water hardness level is
explained in Water Softening System
section.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjusting the amount of rinse aid
1. After switching on your machine, press
the Menu key for 3 second.
Some models require pressing Menu
key once to enter settings menu.
2. Using <- and +> keys, proceed to "P:" on
the display.
3. Set to the appropriate level with the
Selection key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
)
33/EN
Advertisement
