Table of Contents
Advertisement
3-18.
MAIN
SLIDER (Fig. 3-20)
})
Remove timing belt. (Refer to 3-3.)
2)
Remove CAP brake assembly. (Refer to 3-4.)
3)
Remove cam motor chassis block assembly. (Refer to 3-16.)
4)
Remove screw @ to remove retainer @.
5)
Pull out main slider ©.
[Note on Mounting]
* Apply FLOIL SG-055G (Jig Ref. No. J-12) as shown in Fig. A.
+ At the last, slide main slider fully in the arrow @ direction.
Each 3 drops
(Wall surface)
a aINPs
Bottom side
1/2 drop(Apply to
outside position)
ra
Each 3 drops
'
(Bpth wall surface)
~.
Apply grease all over the gear
(Apply until inside of gear)
@ Screw (3 x 8)
3 drops
3 drops
(Wall surface)
Apply to wall surface
@ Retainer
\
Fig. A
Fig. 3-20
Advertisement
Chapters
Table of Contents
