Siemens SITRANS L Compact Operating Instructions page 84
Controllers with ultrasonic transducer inputs
Hide thumbs
Also See for SITRANS L:
- Operating instructions manual (269 pages) ,
- Compact operating instructions (106 pages) ,
- Application examples (11 pages)
Table of Contents
Advertisement
Commissioning
6.5 Local commissioning
Step: Pump control mode
Pump control mode
Sets the control algorithm used to activate the relay.
Setting
Default
This step is only visible if previous step "Number of pumps" is set to a value greater than one.
Step: Pump control
Note
Step is repeated per pump
The parameters in this step will need to be set for each pump used in the application.
Pump 1
Sets relay assigned to pump.
Setting
Default
84
•
Alternate duty assist
•
Alternate duty backup
•
Service ratio duty assist
•
Service ratio duty backup
•
Fixed duty assist
•
Fixed duty backup
Alternate duty assist
•
Relay output 1
•
Relay output 2
•
Relay output 3
•
Relay output 4
•
Relay output 5
•
Relay output 6
Not applicable
SITRANS LT500 with ultrasonic transducer inputs
Compact Operating Instructions, 02/2024, A5E52021877-AA
Advertisement
Table of Contents
