Table of Contents
Advertisement
About this task
NOTE:
This procedure applies only to computers with a plastic chassis.
The following images indicate the location of the camera module and provide a visual representation of the installation
procedure.
Steps
1. Using the alignment post, adhere the camera module on the display back-cover and antenna assembly.
2. Connect the display cable to the connector on the camera module.
Next steps
1. Install the
display
panel.
2. Install the
display
hinges.
3. Install the
display
bezel.
4. Install the
display hinge
5. Install the
display
assembly.
6. Install the
wireless
card.
7. Install the
base
cover.
8. Follow the procedure in
Display cable
Removing the display cable
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display hinge
6. Remove the
display
bezel.
7. Remove the
display
hinges.
102
Removing and installing Field Replaceable Units (FRUs)
caps.
After working inside your
Before working inside your
caps.
computer.
computer.
Advertisement
Table of Contents
