Table of Contents
Advertisement
LED board
Description
LED board (includes cable)
Before removing the LED board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the LED board:
1.
Disconnect the LED board from the system board (1).
2.
Lift to release the LED board cable from the adhesive that secures it to the computer (2).
3.
Remove the Phillips PM2.5×3.0 screw (3) that secures the LED board to the computer.
4.
Remove the LED board and cable from the computer (4).
Reverse this procedure to install the LED board.
Bottom cover on page
Battery on page
37).
36).
Component replacement procedures
Spare part number
848246-001
59
Advertisement
Table of Contents
Troubleshooting
