Table of Contents
Advertisement
Lock bracket
Before removing the lock bracket, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery (see
6.
Disconnect the display assembly (see
Remove the lock bracket:
1.
Remove the Phillips PM2.5×5.0 screw (1) that secures the lock bracket to the base enclosure.
2.
Remove the bracket (2).
Reverse this procedure to install the lock bracket.
Bottom cover on page
Battery on page
37).
Display assembly on page
36).
65).
Component replacement procedures
73
Advertisement
Table of Contents
Troubleshooting
