Table of Contents
Advertisement
12. Insert two tabs of the keyboard into the slits of the computer case and seat the
keyboard at the original position. Refer to Figure 8-9 for tabs and slits. Fix it
with three screws removed in 6.
CAUTIONS: Be sure to use all screws that were removed in 6 and do not
leave foreign matters such as adhesive tape used in 9 or screws removed
and dropped in the computer.
13. Seat the keyboard brace in the original position.
14. Replace the battery pack as described in Chapter 6,
Modes.
15. Turn the power on and make sure the added memory is recognized. Open
System Properties in the Control Panel and click the General tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode then:
1. Be sure the power is off and all cables are disconnected from the computer.
2. Turn the computer upside down and remove the battery.
3. Follow the instructions 4 through 9 in "Installing memory module" to appear
memory module.
4. Push the latches to the outside to release the module. A spring will force one
end of the module up.
5. Pinch the module by the sides and pull it out.
CAUTIONS: 1. If you use the computer for a long time, the memory
modules and the circuits locating close to the memory
modules will become hot. In this case, let them cool to
room temperature before you replace them. Or you will
get burnt if you touch any of them.
2. Do not touch the connectors on the memory module or
on the computer. Debris on the connectors may cause
memory access problems.
Get other manuals https://www.bkmanuals.com
Memory expansion
Power and Power-up
8-13
Advertisement
Table of Contents
