Removing A 3.5-Inch Hard Drive - HP ProDesk 405 G1 Microtower Hardware Reference Manual
Hide thumbs
Also See for ProDesk 405 G1 Microtower:
- Specification (51 pages) ,
- Maintenance and service manual (165 pages) ,
- Disassembly instructions manual (16 pages)
Table of Contents
Advertisement
8.
If installing a USB 3.0 media card reader, connect the media card reader 3.0 cable to the USB
3.0 to USB 2.0 adapter (1) and connect the adapter to the connector on the system board
labeled MEDIA (2).
NOTE:
drive connectors.
9.
Replace the front bezel.
10.
Replace the computer access panel.
11.
Reconnect the power cord and any external devices, then turn on the computer.
12.
Lock any security devices that were disengaged when the access panel was removed.
Removing a 3.5-inch hard drive
NOTE:
Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive.
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5.
Remove the computer access panel.
28
Chapter 2 Hardware upgrades
Refer to
System board connections on page 12
Regardless of the power-on state, voltage is always present on the system board
for an illustration of the system board
Advertisement
Table of Contents
