Table of Contents
Advertisement
To break emulator execution on signal from BNC
1 Enter the modify configuration command.
2 Answer "yes" to the "Modify interactive measurement specification?" question.
3 Answer "drive" to the "Should BNC drive or receive Trig1?" question.
You could also break emulator execution on a trigger signal from the BNC over the
trig2 internal line by specifying that the BNC should drive trig2 and that the
emulator break should receive trig2.
To arm the emulation analyzer on signal from
CMB
1 Enter the modify configuration command.
2 Answer "yes" to the "Modify interactive measurement specification?" question.
3 Answer "drive" to the "Should CMBT drive or receive Trig2?" question.
4 Answer "receive" to the "Should Analyzer drive or receive Trig2?" question.
5 Use the arm_trig2 option to the trace command.
Chapter 9: Making Coordinated Measurements
Using Trigger Signals
311
Advertisement
Table of Contents
