Table of Contents
Advertisement
Connecting KNX
Checking the connection to the channels
The position of the relay contacts of a channel can be changed with a command via the bus or manually
using tools.
This test can be used to check whether the consumers of the channels have been connected correctly.
Siemens Switzerland Ltd
Building Technologies Division
International Headquarters
Theilerstrasse 1a
CH-6300 Zug
WARNING
Manual operation of the slide switch is intended only as an
emergency option or for testing during installation. No telegram is
sent to the bus and the changed switch position is not registered by
the device.
In case of bus failure/recovery, a manually switched relay is moved
into in the parameterized switching state.
DS01
Siemens Switzerland Ltd 2019
Subject to change
Cu
0.6 – 0.8 mm
Update: http://www.siemens.com/gamma-td
11 / 13
January 2019
Advertisement
Table of Contents
