Page 1
Monocrystalline Solar Module LGXXXN1C(W, K)-A3 LGXXXN1C(W, K)-B3 Installation Instructions A minimum slope of 5 in/ft. for installation over a roof, is required to maintain the fire class ratings. The array frame shall be grounded in accordance with NEC Article 250. MFL68783801...
Safety The instructions related to safety and use indicated in Do not scratch the coating surface of the frame. the this installation manual are intended for the Scratches may decrease the total solar output prevention of unexpected danger, damage, or failure. due to corrosion of the frame.
Before & After Installation Before Installation • Dirt build-up on the surface of the panel may cause active solar cells to be shaded and electrical Please carefully read this manual before installation. performance to be impaired. • Contact with electrically active parts of the panels, such as terminals, may result in burns, sparks and •...
Page 5
Diodes unbalanced string voltage. • All LG modules are equipped with factory installed • A multiplying factor is required for increased output bypass diodes. The factory-installed diodes provide of the PV modules. Under normal conditions, a PV...
50lb/ft2 (about 2400 Pa). Electrical Installations, Canadian Electrical Code, Excluded Operating Environments Part 1. • The solar modules from LG Electronics can not be operated in a location where they could come in direct contact with salt water or ammonia.
Page 7
Mechanical Installation Mounting Methods Mounting by using frame bolts holes • Secure the solar module to the structure by using General Information the factory mounting holes. • Select the appropriate orientation to maximize • Four M6 stainless steel bolts, four nuts, four spring sunlight exposure.
Page 8
Mechanical Installation LGXXXN1C(W, K)-A3 LGXXXN1C(W, K)-B3 Use four mounting holes on two opposite sides. Clamping Range (230mm) 270mm 270mm Use four clamps on the long frame. This method is not tested by IEC/UL. Center ± 100mm Clamping Range: Clamping Range: From module Edge From module Edge to 270mm...
LG with any questions or concerns. By installing an LG Solar module, I discharge, and cove nant not to sue LG, its affiliated companies, successors, or assigns, its administrators,...
Appendix WILEY Compatibility • LG modules have been confirmed by Burndy LLC that the below model number designations have been evaluated with the Burndy WEEB line of products : For Verification of Compatibility LG modules have been Compatibility, tested by UL.
Page 13
Appendix A portion of the grounding devices indicated on this page is not evaluated by UL. If such devices want to be used to meet the requirement in UL 1703, some adequate tests shall be conducted in accordance with UL1703 additionally. - WEEBs - Grounding Lugs - Cable Clips...
Page 14
Contact : lg.solar@lge.com http://www.lgsolarusa.com This document is subject to change without notice. LG, LG logo and Life's Good are trademarks of LG Electronics, Inc. worldwide. Trademarks and intellectual properties of LG Electronics, Inc. are protected by international copyright laws. Document : II-A3(N)-UL-V5-EN-201308...