Table of Contents
Advertisement
Picture ID
Picture ID is used to change the settings of a
specific display using a single IR receiver for
multi-vision. The set receiving the IR signal
communicates with another set via an RS232
connection. Each set is identified by a Set ID. If
you assign the Picture ID using the remote control,
only displays with the same Picture ID and Set ID
can be controlled remotely.
AUDIO
(RGB/DVI)
RS-232C OUT
AUDIO
(RGB/DVI)
RS-232C OUT
RS-232C IN
REMOTE
CONTROL IN
REMOTE
CONTROL IN
POWER
MONITOR
IR Receiver
OFF
ON
SET ID:1
. , !
GHI
PQRS
1/a/A
MARK
ARC
SET ID:3
3D
2X2 Multi-Vision (Total Set ID: 4)
MUTE
Set IDs are assigned as shown in the picture.
AUTO
MENU
1
Press the red ON button on the remote control
to assign the Picture ID.
OK
BACK
TILE
ID
ON
OFF
RS-232C OUT
RS-232C OUT
RS-232C OUT
RS-232C OUT
RS-232C IN
RS-232C IN
RS-232C IN
RS-232C IN
RS-232C IN
ENERGY
INPUT
SAVING
SET ID:2
ABC
DEF
JKL
MNO
Picture ID
◄
Off
►
TUV
WXYZ
Close
CLEAR
- * #
P
BRIGHT
A
SET ID:4
NESS
G
E
S.MENU
EXIT
PSM
CUSTOMIZING SETTINGS
2
If you press the left/right buttons or press the
ON button repeatedly, the Picture ID cycles
through OFF and 1 to 4. Assign the ID you
want.
Picture ID
Off
◀
Close
If you assign the Set ID to each set with
y
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
POWER
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
ENERGY
MONITOR
be controlled by IR signals.
OFF
ON
The maximum value of the Picture ID can be
SAVING
y
set in the Total Set ID menu.
. , !
ABC
Please refer to the Installation Manual for
y
more information on Total Set ID assignment.
GHI
JKL
PQRS
TUV
1/a/A
- * #
MARK
ARC
NOTE
3D
For example, if the Picture ID is assigned to
y
MUTE
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
AUTO
MENU
For each set, you can change the settings
y
for the PICTURE, AUDIO, TIME, NETWORK
and MY MEDIA menus or the hot keys on
OK
the remote control.
If you press the green OFF button for Picture
y
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
BACK
TILE
ID
control, all sets will start working again.
ON
OFF
Picture ID will be disabled while using the
y
MY MEDIA menu.
53
▶
INPUT
DEF
MNO
WXYZ
CLEAR
P
BRIGHT
A
NESS
G
E
S.MENU
EXIT
PSM
Advertisement
Table of Contents
Troubleshooting
