Table of Contents
Advertisement
Delivery and subsequent transportation of the equipment
The customer should prepare his environment to accept the new product based on the installation
planning information provided, with assistance from an IBM Installation Planning Representative (IPR) or
IBM authorized service provider. In anticipation of the equipment delivery, the final installation site should
be prepared in advance such that professional movers/riggers can transport the equipment to the final
installation site within the computer room. If for some reason, this is not possible at the time of delivery,
the customer will need to make arrangements to have professional movers/riggers return to finish the
transportation at a later date. Only professional movers/riggers should transport the equipment. The IBM
authorized service provider will only perform minimal frame repositioning within the computer room, as
xiv IBM Storage Networking: IBM Storage Networking SAN48C-6 32 Gbps 48-Port Fibre Channel Switch
Installation, Service, and User Guide
DANGER: When working on or around the system, observe the precautions:
Electrical voltage and current from power, telephone, and communication
cables are hazardous. To avoid a shock hazard:
• Connect power to this unit only with the IBM provided power cord. Do not
use the IBM provided power cord for any other product.
• Do not open or service any power supply assembly.
• Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical
storm.
• The product might be equipped with multiple power cords. To remove all
hazardous voltages, disconnect all power cords.
• Connect all power cords to a properly wired and grounded electrical
outlet. Ensure that the outlet supplies proper voltage and phase rotation
according to the system rating plate.
• Connect any equipment that will be attached to this product to properly
wired outlets.
• When possible, use one hand only to connect or disconnect signal cables.
• Never turn on any equipment when there is evidence of fire, water, or
structural damage.
• Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
• Connect and disconnect cables as described below when installing,
moving, or opening covers on this product or attached devices.
To disconnect:
1. Turn off everything (unless instructed otherwise).
2. Remove the power cords from the outlets.
3. Remove the signal cables from the connectors.
4. Remove all cables from the devices.
To connect:
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. Attach the power cords to the outlets.
5. Turn on the devices.
(D005)
Advertisement
Table of Contents
