Sony HSCU300RF Operation Manual
Hd camera control unit
Hide thumbs
Also See for HSCU300RF:
- Operation manual (34 pages) ,
- Manual (30 pages) ,
- Service manual (134 pages)
Advertisement
Quick Links
HD Camera Control Unit
Operation Guide
HSCU300RF
HSCU300R
© 2013 Sony Corporation
Printed in Japan
English
Before operating the unit, please read this manual thoroughly and retain it for
future reference.
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
THIS APPARATUS MUST BE EARTHED.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
WARNING: THIS WARNING IS APPLICABLE FOR USA ONLY.
If used in USA, use the UL LISTED power cord specified below.
DO NOT USE ANY OTHER POWER CORD.
Plug Cap Parallel blade with ground pin (NEMA 5-15P Configuration)
Cord
Type SJT, three 16 or 18 AWG wires
Length
Minimum 1.5 m (4 ft 11 in), Less than 2.5 m (8 ft 3 in)
Rating
Minimum 10A, 125V
Using this unit at a voltage other than 120V may require the use of a different
line cord or attachment plug, or both. To reduce the risk of fire or electric shock,
refer servicing to qualified service personnel.
4-479-632-11 (1)
WARNING: THIS WARNING IS APPLICABLE FOR OTHER COUNTRIES.
1. Use the approved Power Cord (3-core mains lead) / Appliance Connector /
Plug with earthing-contacts that conforms to the safety regulations of each
country if applicable.
2. Use the Power Cord (3-core mains lead) / Appliance Connector / Plug
conforming to the proper ratings (Voltage, Ampere).
If you have questions on the use of the above Power Cord / Appliance Connector
/ Plug, please consult a qualified service personnel.
For kundene i Norge
Dette utstyret kan kobles til et IT-strømfordelingssystem.
(HSCU300RF only)
Caution
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
This HD Camera Control Unit is classified as a CLASS 1 LASER PRODUCT.
Tämä HD-kameraohjausyksikkö on luokiteltu 1. LUOKAN LASERTUOTTEEKSI.
Den här kontrollenheten för HD-kamera klassificeras som en LASERPRODUKT
AV KLASS 1.
Caution
The use of optical instruments with this product will increase eye hazard.
For the customers in the U.S.A.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
You are cautioned that any changes or modifications not expressly approved in
this manual could void your authority to operate this equipment.
All interface cables used to connect peripherals must be shielded in order to
comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC
Rules.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
For the customers in Canada
CAN ICES-3 (A)/NMB-3(A)
For the customers in Europe
This product with the CE marking complies with the EMC Directive issued by the
Commission of the European Community.
Compliance with this directive implies conformity to the following European
standards:
ˎ
ˎ
EN55103-1: Electromagnetic Interference (Emission)
ˎ
ˎ
EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following Electromagnetic Environment:
E4 (controlled EMC environment, ex. TV studio).
For the customers in Europe, Australia and New Zealand
WARNING
This is a Class A product. In a domestic environment, this product may cause
radio interference in which case the user may be required to take adequate
measures.
For the customers in Europe
This product has been manufactured by or on behalf of Sony Corporation,
1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. Inquiries related to product
compliance based on European Union legislation shall be addressed to the
authorized representative, Sony Deutschland GmbH, Hedelfinger Strasse 61,
70327 Stuttgart, Germany. For any service or guarantee matters, please refer to
the addresses provided in the separate service or guarantee documents.
This apparatus shall not be used in the residential area.
For the State of California, USA only
Perchlorate Material - special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material : Lithium battery contains perchlorate.
For the customers in Taiwan only
For the customers in the U.S.A.
SONY LIMITED WARRANTY - Please visit http://www.sony.com/psa/warranty
for important information and complete terms and conditions of Sony's limited
warranty applicable to this product.
For the customers in Canada
SONY LIMITED WARRANTY - Please visit http://www.sonybiz.ca/solutions/
Support.do for important information and complete terms and conditions of
Sony's limited warranty applicable to this product.
For the customers in Europe
Sony Professional Solutions Europe - Standard Warranty and Exceptions on
Standard Warranty.
Please visit http://www.pro.sony.eu/warranty for important information and
complete terms and conditions.
For the customers in Korea
SONY LIMITED WARRANTY - Please visit http://bpeng.sony.co.kr/handler/
BPAS-Start for important information and complete terms and conditions of
Sony's limited warranty applicable to this product.
Overview
ˎ
ˎ
The HSCU300RF Camera Control Unit connects to a Sony HSC300RF or
HSC100RF HD color camera via an optical fiber cable. It performs signal
processing, provides an interface for external equipment, and supplies power
to the camera.
ˎ
ˎ
The HSCU300R Camera Control Unit connects to a Sony HSC300R or HSC100R
HD color camera via a triaxial cable.
It performs signal processing, provides an interface for external equipment,
and supplies power to the camera.
Using the CD-ROM manual
The manual can be read on a computer with Adobe Reader installed.
You can download Adobe Reader free from the Adobe website.
1 Open the index.html file in the CD-ROM.
2 Select and click on the manual that you want to read.
Note
If you have lost or damaged the CD-ROM, you can purchase a new one from your
Sony dealer or Sony service counter.
Advertisement
Related Manuals for Sony HSCU300RF
Summary of Contents for Sony HSCU300RF
- Page 1 WARNING: THIS WARNING IS APPLICABLE FOR OTHER COUNTRIES. 1. Use the approved Power Cord (3-core mains lead) / Appliance Connector / This product has been manufactured by or on behalf of Sony Corporation, Plug with earthing-contacts that conforms to the safety regulations of each 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan.
- Page 2 XLR 3-pin, male (2), 0 dBu / –20 dBu changes caused by manual switching): ˎ ˎ SONY WILL NOT BE LIABLE FOR CLAIMS OF ANY KIND MADE BY USERS OF 43 A peak, 5.5 A r.m.s. (240 V AC) THIS UNIT OR MADE BY THIRD PARTIES. Supplied accessories (2) Inrush current after a mains interruption of five seconds ˎ...