Table of Contents
Advertisement
Revision 09/04
No. Designation
1 Base plate
2 Spacer bar
3 Load cell
4 Washer
5 Hexagon head screw
6 Nut
7 Half-nut
8 Washer
9 Countersunk screw
Fig. 3-1 Structure of combination mounting unit
3.2
Assembly
The conditions for installation are very different. The load platform can be very low or
relatively high. It could be a hopper, a platform or a conveyor for example. The following
assembly instructions can only be taken as general guidelines.
WARNING
Proper tools are to be used for lifting the load platform. Ensure that the respective
safety regulations are followed.
The load platform should always be built on dummies to begin with, so that the load cells
are protected from damages during assembly. The load platform must then only be lifted
a few millimeters from bracket to bracket to position the combination mounting unit. The
following description of assembly is based on this situation.
Document No.: A5E00353789B
Comb. Mounting Units
No.
Designation
10 Nut
11 Overload protection
12 Retaining ring
13 Oscillation housing
14 Force guiding piece
15 Flat seal
16 Pendulum bolt
17 Force guiding piece
18 Top plate
Page 23
Advertisement
Table of Contents
