Table of Contents
Advertisement
Installing the Device
2.1 General Procedure
Note
This product should be installed in a restricted access location where access can only
be gained by authorized personnel who have been informed of the restrictions and
any precautions that must be taken. Access must only be possible through the use
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1
General Procedure
The general procedure for installing the device is as follows:
Note
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
7.
8.
2.2
Unpacking the Device
When unpacking the device, do the following:
1.
2.
3.
IMPORTANT
If any item is missing or damaged, contact Siemens for assistance.
10
Review the relevant certification information for any regulatory requirements.
For more information, refer to
Mount the device.
Connect an antenna or antennas.
For LTE antennas only, install SIM cards.
Connect the failsafe alarm relay.
Connect power to the device and ground the device to safety Earth.
Connect the device to the network.
Configure the device.
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
"Approvals (Page
49)".
Installation Manual, 01/2021, C79000-G8976-1103-17
RUGGEDCOM RX1400
Advertisement
Table of Contents
