Table of Contents
Advertisement
GE
D
KTI106052, R
IRECTION
3-5-1-2
Mounting small Peripherals (e.g., Black & White Printer)
1.) Place the B&W Printer on the lower peripheral shelf of the Modo Cart.
2.) Take a Velcro tape and pull it under the shelf (left image at
3.) Pull up the Velcro tape on the left side. The other end of the tape place on the printer
(right image at
4.) Place the end of the Velcro tape on the top of the other end (left image at
NOTE:
Make sure that the Velcro tape is firmly fastened. For reference see:
5.) Connect the peripheral device and mount the pull out protection of the power cable.
Links to connection schemes can be found in
NOTE:
A power extender cable from the power outlets of the Modo Carts isolation transformer should be used
to connect peripheral devices. Please connect the power extender cable to the peripherals first,
then connect the other end to the isolation transformer of the Modo Cart.
(Cables can be routed inside the cable management clips, see:
General using cable
Figure 3-24 Connect peripheral device to the Modo Cart (isolation transformer)
10
EVISION
Figure 3-22 pull Velcro tape under shelf and printer
Figure
3-22, above).
Figure 3-23 fasten Velcro tape
Chapter 3 - Setup Instructions
Figure 3-22
Figure 3-21 on page
Table 3-9, "Connection Procedures," on page
Figure 3-11 on page
Connect B/W printer
or Color printer
Connect isolation
transformer
V
i / V
OLUSON
OLUSON
S
M
ERVICE
ANUAL
below).
Figure 3-23
below).
3-26.
3-23.
3-15.)
3-27
e
Advertisement
Table of Contents
Troubleshooting
