Protecting The Environment - DeWalt DCW210 Manual
Hide thumbs
Also See for DCW210:
- Original instructions manual (145 pages) ,
- Instruction manual (41 pages) ,
- Manual (25 pages)
Table of Contents
Advertisement
EnGLIsH
The charger and battery pack are not serviceable.
Replacing the Sanding Pad and the Belt
(Fig. G)
Your sander is equipped with a replaceable belt
is located between the pad
designed to control the pad speed while the unit is off the work
surface. The belt and the sanding pad
consumable parts and will occasionally need to be replaced. The
sanding pad needs replacement when signs of wear become
evident. Replacement of the belt is necessary when the pad
speed increases very dramatically when the unit is lifted from
the work surface. These parts are available at extra cost from
your local dealer or authorised D
1. Holding the platen firmly, remove the four screws
the bottom of the pad.
2. Remove the pad
6
.
3. Replace worn or damaged belt
the shoulder screw
15
in Figure G.
4. Reinstall pad (replace with new pad if necessary). Replace
the four screws
. Be careful not to over-tighten screws.
14
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
34
13
which
6
and the sander body
12
6
are designed to be
WALT service centre.
e
13
by wrapping it around
and bearing retainer
as shown
16
WALT recommended
e
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
. It is
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
14
from
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Hide quick links:
Advertisement
Table of Contents
