Table of Contents
Advertisement
7.
Install the removed parts by reversing the steps of removal.
4-3-2.
MEM-147 Board/TX-146 Board
Preparation
1.
Remove the outside panel assembly. (Refer
Procedure
1.
Disconnect the two FPCs with connectors (DPR-SDI) from the two connectors (CN001, CN102) on the MEM-147
board.
2.
Disconnect the two fine-wire coaxial cables from the two connectors (CN901, CN902) on the MEM-147 board,
and release the two fine-wire coaxial cables from the clampers.
CN902 CN901
Clamper
Fine-wire coaxial cables
3.
Release the fine-wire coaxial cable and coaxial cables from the clamper.
4.
Disconnect the three coaxial cables from the three connectors (SDI1, SDI2, and PROMPTER2) on the MEM-147
board.
5.
Disconnect the fine-wire coaxial cable from the connector (CN501) on the MEM-147 board.
HDC4300
to"4-3-1. Outside Panel
MEM-147 board FPCs with connectors (DPR-SDI)
CN001
CN002
Assembly")
4-7
Advertisement
Table of Contents
