Table of Contents
Advertisement
Communications configuring
Error code
Explanation
0xB210
OK
0xB211
Logical module address invalid
0xB212
Data set number not valid
0xB213
Invalid table data format
0xB214
The data format of the new data set
does not match that of the previously
transferred data set
0xB215
FM 458 does not respond
0xB216
Table is too large
0xB217
Table is not complete (X / Y values)
0xB218
REQTAB is reset during processing
0xB219
REQDB reset during processing
0xB21A
DB number is not valid
0xB21B
TIMEOUT when receiving the
acknowledge telegram
0xB21C
Invalid processing status
3.18.2
Manual mode
3.18.2.1
Application
Entering tabular
values
3-182
The following errors can occur and are displayed at the ERROR output:
Errors associated with the SFC58 or SFC59 are displayed at the ERROR
output.
The "Manual mode" mode represents the simplest way of inserting
tabular values into a configured software package. However, it is
comparatively time consuming as data has to be manually entered or
taught-in from the program.
After the TAB or TAB_D has been correctly configured, the tabular values
can be entered one after another. To start off with, the table size, i.e. the
number of value pairs (=points) should be specified at input NP. If the
table is to be saved in the SAVE area, then input SAV of the must be 1.
Remedy
-
Specify a valid module address at input
LADDR.
Enter the tabular values in an increasing
sequence in the DB.
Tabular values must have data type REAL for
the TAB and data type DINT for the TAB_D.
Ensure that all of the tabular values have the
same data format.
Check the communications connection and
configuring.
Transfer the table in sub-sets, i.e. either
distribute tabular values over several DBs or
after each partial transfer write new
(additional) tabular values into DB and
transfer.
Complete the table, there must be a Y value
for each X value.
Transfer the tabular values again.
Transfer the tabular values again.
Specify a valid DB number.
Check the communications coupling and
configuring. Transfer the tabular values again
Check the configuring of the WR_TAB.
System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
- Quick Links:
- Software and Hardware
Hide quick links:
Advertisement
Table of Contents
